I finished my wiring of my CF8, and everything appears to be working. Most difficult and frustrating build ever, I.e. a good learning experience.

However, I misjudged the space the wires would take up, and now it will not fit inside my hilt. I am using a saberforge Dissident hilt which has around a 1.1 ID.

Is it possible to increase the inner diameter of the body tube while leaving the threads alone? Sandpaper, dremel, lathe?

I’ve sent an email to saberforge to see if it isn’t something their workshop could do as well. Just wanted to see if anyone else has been in the same situation.