Hey all. So I decided to also convert my Black Series Vader
For right now this is just the disassembly and primary wiring
So first of all, remove the screws on the shroud
And then this screw, and another on the opposite side (same as this one)
Then remove this screw and disassemble the switch area
Like I did with my Luke, I marked with a sharpie a wire to differentiate
I took this a step further and instead of desoldering the leads, I clipped them, and extended the wires
Now tuck it in
You will then be able to remove the innards. Just lside them out
Now to remove these two pins
One of these pins is covered by the tape that adds detail to the saber
I just peeled it back a bit and proceeded to tap out the pins with a punch
Now the blade should come out.
Disassemble the housing and you should be here
Exactly like the Luke, bridge what you see and add a wire to each lead
This one was a bit messier for me than the Luke. I tried to clean up the solder a bit, but I had no desoldering braid
Hopefully it still works well
Next update will be the LED
Using a XPE-2 Deep Red Cree with a 2ohm 1 watt resistor
A 1" heatsink module from TCSS with an 8.7 degree lens
Bookmarks