Hallo everyone!
I admit it, I am new here, and I hope you forgive me my question and I haven't over-read something.

After reading the general econo-thread I came up for my desired layout with this wiring:


I hope I didn't make a calculation-error.
So far everything was clear, until I "unpacked" my board and got something like this:


The saber is the new Ultimate FX Vader (this one: http://www.entertainmentearth.com/im...HSA0861Blg.jpg ). Which of all these things are the LED- and/or +-contacts? There are just too many of them! And can I simply remove everything else or does it not work then anymore?
"Hit1" in the middle goes to the clash-sensor. How can I keep the thing on, while removing the rest? Or can I simply cut off the LED-strip?


Also does someone know which of the wires is for the "off", "trial" or "on"-version on the saber (and how to wire it to permanent on)?
This is the backside of the main-Board:
and
"TRY" with the yellow wires goes to the switch, green goes to the speaker.

This is the small card, that is placed under the switch for changing on/off/trial-mode:
backside:
front: The switch itself is labeled "SW1", VDD goes to the + of the batterie.

I hope someone can bring some light into that mess and help me!
Greetings
Bookworm