First saber

[Wardarth]

I used another thread as a base for the items i need, I have no clue if this is even close so any help is HUGELY appreciated.

x1: 8-32 x 1/2" thumb screw

x1: LED "Corbin style" Show blade 1" OD (36 inches)
Quad Wrap
Bullet Shaped

x1: 8-32 Tap & drill set

x1: Tap handle

x1: 7" Fluted with guarded style switch hole

x1: Screw on LED blade holder style 20

x1: MHS "new style" Heat Sink V2

x1: MPS Pommel style 7

x1: Main Body Powder Coating (Wet Black) (DFS2)

x1: Blade Holder Powder Coating (Extreme Chrome) (B201)

x1: Pommel Powder Coating (Extreme Chrome) (PM71)

x1: Build Your Own Seoul P4 Electronics Kit
4AAA Battery Holder with JST connector
Seoul P4 (Red)
Collimator Lens 5° viewing angle
4.7ohm 5w resistor
(Switch07) SPST Push on/off - Mom switch with black button
Seoul P4 Lens Holder

x1: 16mm Anti Vandal Latching Red Ring Switch

x1: Red momentary switch

x1: MPS Clip

x1: MPS Insert style 6

x1: Black machined button for Covertec clip

x1: MHS speaker and 4x AAA battery holder

x1: Petit Crouton Sound Module V2.0
Light Meat

x1: 8-32 x 1/4" socket head

x1: Activation box style 19

x1: Box 19 Mounting holes service
location: Where the existing design hole goes if possible.

x1: Seoul P4 (Red)

x1: Collimator Lens 8.7 deg viewing angle

x1: Seoul P4 Lens Holder

x2: 26 gauge wire (sold by the foot) (Black)

x2: 26 gauge wire (sold by the foot) (Blue)

x2: 26 gauge wire (sold by the foot) (Brown)

x2: 26 gauge wire (sold by the foot) (Green)

x2: 26 gauge wire (sold by the foot) (Grey)

x2: 26 gauge wire (sold by the foot) (Orange)

x2: 26 gauge wire (sold by the foot) (Purple)

x2: 26 gauge wire (sold by the foot) (Red)

x2: 26 gauge wire (sold by the foot) (White)

x2: 26 gauge wire (sold by the foot) (Yellow)

saber diagram.jpg


Anything i've done wrong ie: something i do or dont need please let me know.
I have no clue whatsoever about electronics so small words are appreciated.