First MHS Saber Build, Need Verification of my Parts List

[PeDDeR27]

I plan on making my first MHS saber soon. This saber is just going to be a stunt saber for now, but then eventually I plan on adding sound. For now this saber is going to be pretty basic, with an Illuminated AV Switch and Recharge Port. Can someone go through my parts list and make sure I have everything to make this work and be a complete build? I would really appreciate it! And let me know if you recommend anything else or to add something to my list. Thanks!

BTW, I already have the LED I want to use. Rebel Star Bin 1 Cyan. And the reason I have so many JST connectors is because I plan on having everything connected with the JST wires, so that when I buy my MWS Pre-Wired PC Sound Board, I can just basically drop it in and be done.

Hilt:
4” Double Female Grooved Without Holes
MHS Blank Extension Style 1
MHS Choke Style 1 Short
Screw On LED Blade Holder Style 9
MPS Pommel Style 4
MPS Insert Style 4
MPS Clip
Activation Box Style 9
8-32 x 1/8” Set Screw (for blade retention)

Blade:
LED “TCSS Style” Show Blade 1” OD (32 Inches)

Services:
Drill & Tap Hole (8-32) (for Blade set screw)
Box 9, 10, and 17 Mounting Holes Service

LED:
MHS “New Style” Heat Sink V2
Collimator Lens 8.7 Deg Viewing Angle
Luxeon Rebel Lens Holder
Star Thermal Tape Pad

Electronics:
MWS BuckPuck (1000mA)
16mm Anti-Vandal Latching Blue Ring Switch
7.4v Li-Ion 800mAh 14500 Battery Pack
2.1mm Power Jack
JST Connectors (7)
220ohm 1/4w Resistor (for switch LED)

Misc:
Kill Plug Style 5
1” Hilt Safety Plug (Trans White)
3.7v-14.8v Li-Ion Smart Charger
Tamiya to JST Charger Adapter