I've been looking at some older posts about over driving and could use some clarification. I'm well aware life spans and danger blah blah yakity smakity...

So the options you have are:

Constant current driver
The other driver in the store (I forget what it was listed as but you can set the output)
Or using two buck pucks.

Since current and voltage are relational, would using a smaller rated resistor have a similar affect or would it just fry the LED?
For example: if I were to use a 1ohm 2w resistor when having used ohms law to calculate 1.1ohms 2.17w as per the luxeon3 red /o

I understand there's a lot of other factors we can't control ( the luck of the draw right) but in a perfect world and the led runs to it's listed specs...