Over the next few months there will be a major change in the blade holder setups. We will be changing the blade holders to accept a unit similar to the MLS unit UltraSabers had designed. The main difference is that our setup will not take up anymore room inside the hilt as it will all be inside the blade holder as before. We will also offer a way to make the blade holder backwards compatible with the old setup. This solves a few issues..

1. The blade holder will have a 1" hole all the way through for custom jobs

2. The LED module will have a screw in heatsink so LED/lens height will not matter as you can screw the assembly in farther for a Rebel, etc..

We will get all of the components necessary ready to go over the next month or so and after that when a blade holder runs out it will be restocked with the new design. At that point the blade holders will be offered by themselves and you can choose to add a setup to make it backwards compatible or get the new Heat sink/lens holder setup.