I will have to check when i get home but i am 99.9% certain that when using this as a guide:
that i specifically left the NC prong un-soldered and isolated via heatshrink...
*edit* Now that i think of it, i believe the switch worked as normal before rewiring the accents... Just the LED didn't light up.
*edit edit* I went home and checked and yes, the only prong not soldered is the Normally Closed, the others are wired up as stated in the image above so that cannot be the issue... i did find this here that i think will do the job nicely... i will see about getting it and fixing up my wiring, makes me wonder if the L1 pad is simply bad....
Reply With Quote
Bookmarks