Any idea of how to wire in a P7 at 700-900 lumen for the blade? I was thinking of a dual power supply. On for the sound card with the other workings and one power supply for the P7 blade.
Any idea of how to wire in a P7 at 700-900 lumen for the blade? I was thinking of a dual power supply. On for the sound card with the other workings and one power supply for the P7 blade.
You would need very good battery cells for a start e.g. 18650 2600mAh Li-Ion cells then a Driver that can dish out 2.8A, very good heat management and good optics that wont melt with all the heat, sound simple? lol
Take a look at Project Insanity by grand saber smith Do-Clo
http://forums.thecustomsabershop.com...ead.php?t=7957
I don't know...
If your NEW to TCSS READ HERE!! >>>>> http://forums.thecustomsabershop.com...d=1#post108682
if you are going with a sinktube body the 4AA battery packs from radioshack fit perfectly inside. wire two in parrallel with Ni Hm batteries and you have
4.8 volts and about 5000 mAh. but that would take up a lot of room. that would just be the simple way to do it were you not using sound.
but i would ask do clo what he did. more specifically what battery he used.
dont forget you should also use the p7 driver. and also find a good optics to work with it. good luck
Why did you start 2 separate threads in 2 different forums about the same thing, bzylman? It really wasn't necessary.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
i was wondering the same thing.... newbs
Bookmarks