-
-
Search Madhatter. He did a 10W LEDengin with a CF 4.0
Erv also uses a 10W green in his saber
I for one am planning on upgrading my steampunk Luke toa LEDengin Green. 3 dies in parallel, run off a CF @ 1.5A and then the last die Clash flash.
-
-
Banned
Sith Lord
yeah getting the one with all dies seperate so you have seprate solder pads would be the esieast way to go.
but look in my sig.
thats the one with them all in seies. it needs 14.4 volts and 700 ma (1000 max)
im direct driving it with 4 14500s. and man its bright. BUT since the dies are all in series. it drains my batteries 4 times as fast. which gives me about 15 minutes of run time on my li ions.
i should have gotten them all seperate though. heres why:
i could still use 4 14500s but i would have longer run time if each die has an individual battery. that way your run time is around an hour. you could also wire sound to it. take a CF. hook up a 2 14500 battery pack to it and drive two of the dies with the CF. then if you are using the DPST switch or something with a lot of ports like an AV switch you could hook the other 2 single batteries to the same switch and drive the other two LEDs.
i think the AV switches have 3 ports. 1 port for CF and the other two for the other two dies.
i think this would work.... i most likely have something wrong here. please correct me.
Last edited by DJMoonbass; 11-03-2009 at 11:57 AM.
-
-
Banned
Sith Lord
nihm batteries wont work. each die needs 3.6 volts. i would need 3 batteries to power one single die. so like i said wire each individual die to a 3.7 li ion. you are running at full.
but i guess a CF would work at 10.7 volts... and yeah the clash flash would be the perfect thing for the fourth die.
sweet
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks