Page 1 of 3 1 2 3 LastLast
Results 1 to 10 of 25

Thread: Hilt Wiring

  1. #1

    Default Hilt Wiring

    Has anyone had a problem with this, or is it just me?

    I finished my saber, but one thing I noticed was that it leeches the battery even when not on. I put a new 9v into it, had it on for a few minutes, then turned it off. About an hour or two later, I try to turn it on again, and the battery is completely dead.

    Any ideas on where I went wrong?

    Thanks!

  2. #2

    Default

    where did you wire the switch into the circuit? if you wire it onto one of the output wires, there will still be a complete circuit from the battery to the inverter.

    i am a nerd, if you don't like it, i will cut you with my lightsaber

  3. #3

    Default

    *smacks head* Doh!

    I'm not sure, but thinking back, I bet that's exactly what I did...silly me. I got too impatient on finishing the blasted thing... I'll check, but I think that's where I went wrong.

    Thanks!

  4. #4

    Default

    its gonna leach the battery no matter what, its still sending power to the inverter just not as much.

  5. #5
    Owner of the Custom Saber shop Strydur's Avatar
    Join Date
    Oct 2005
    Location
    USA
    Posts
    3,523

    Default

    If you have the switch between the battery and the invert you wont lose any more power than the battery sitting there by itself. I have had a battery sitting in a test saber for 5 months and it still works fine.

    Tim
    The Custom Saber Shop

  6. #6

    Default

    yep, it only sucks the power if you put the switch on an output, i had the same problem when i was a total newbie [] it kinda makes me feel better that i am not the only one with that problem.

    i am a nerd, if you don't like it, i will cut you with my lightsaber

  7. #7

    Default

    lol...Thanks guys!

    ...now pardon me while I fall on my lightsaber. (or should I fix it, and THEN fall on it?)

  8. #8

    Default

    Does anyone have instructions on where and how to wire the switch. Sorry if it has already been explained, but I could'nt find it. I know absolutely nothing about electronics and new to this, so help would be appreciated.
    Thanks![]

  9. #9

    Default

    Did you look through this, its Tims tutorial for That.

    http://www.thecustomsabershop.com/sa...sp?TOPIC_ID=15

    Hope its what you need...

    Cain

  10. #10
    Owner of the Custom Saber shop Strydur's Avatar
    Join Date
    Oct 2005
    Location
    USA
    Posts
    3,523

    Default

    If you have one of the new inverters just hook the switch to the 2 black wires. Just take one of the black wires on the inverter and solder it to one of the switch wires. Then connect the remaining black wire from the inverter to the remaining switch wire..all done. Cant get much easier than that[8D]

    Tim
    The Custom Saber Shop

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •