how to recharge 6v for seoul p4?

[davidg1904]

I bought a rechargeable 6v battery to power my Seoul P4 white LED and now i'm not sure how to recharge it? what connections should I use? what charger? The battery looks like this:
http://vi.ebaydesc.com/ws/eBayISAPI....mdbattery&ds=0

any help?

[davidg1904]

Also any help on wiring this rechargeable batt. I have all the parts (I think) but not quite sure what to do. I don't want to blow my LED. like this?

[Kal El Rah]

1st off, with that setup, just plug the battery pack to the charger only.
2nd why did you pick that battery pack, there are better-cheaper packs available on the net. You should have asked here in the 1st place.

[davidg1904]

1st off, with that setup, just plug the battery pack to the charger only.
2nd why did you pick that battery pack, there are better-cheaper packs available on the net. You should have asked here in the 1st place.

Well the pack fits into my saber (its less than 3/4") and still gets the 6v i want also i want to (semi)permanently install this in the saber and recharge it through a normal 5mm charger jack. BTW my batt. pack is not side by side but on top of each other like my err umm diagram. Any ideas or help?

[Kal El Rah]

Get this from the shop; http://www.thecustomsabershop.com/21...-Jack-P37.aspx

and use this to wire it up; http://forums.thecustomsabershop.com...ead.php?t=2235

[davidg1904]

Thank you so much!!! I don't know why I could not find that before!!! I might even board this thing too! well perhaps my next one.

[Kal El Rah]

Forgot to mention, you can get this as your kill plug and recharge port adapter;

http://www.thecustomsabershop.com/21...plug-P253.aspx