So I am doing 3 versions of the Luke ROTJ V2. Here is the odyssey, chronicled for all to see.
This is where I started (Just ignore the V3...that one comes later.)
Here are all three IN ROUGH TRIM :
Here are the final sabers from LDM's V2 Project. Each is a slightly different version of the Luke ROTJ V2 Lightsaber. The V2 in the foreground is MR-based, weathered and sports an MR 616 soundboard and Corbin V2 driver driving an Green Cree XR-e LED. The V2 in the middle is MHS-based, weathered and sports a Crystal Focus Saber Core v4.2 driving a Seoul P4 Green LED. Finally, the V2 in the back is Scratch-built and has an Ultrasound v2.2 driving a Seoul P4 Green LED.
See the individual sabers' posts for the particulars. :dft012:
The Vid:
The Glams:
Here are a few of the rough build pix of the group:
Now, on to the individual saber builds:
First up, the 11" MHS-based V2 with Buttered Toast.
Particulars:
CF V4.2
"Crystal Pommel"
"easy SD access"
4.8V NiMh Battery solution
Recharge/Kill
"Reverse Sound (TCSS HO Speaker)"
Accent (Power on) LED in Clamp
2 MOM Switch setup (both in clamp)
Seoul P4 Green
(2) 5mm HO Accent LEDs
Custom "D-ring"
Super Secret Weathering Sauce
LDM Cone knob (kill key)
The Video:
The internals (for ISG Purposes):
And, finally...the Finished Toast:
Next up, an US 2.1 "Clean" V2...
It is a Clean Version of the V2. It has a saberforge grenade and "ring". It has a "broken" Park's emitter shroud that I scavenged. The rest is scratch (except the box and greeblies). The neck is 1.125" Aluminum and the neck "ring" is 1.5 OD.
The particulars:
Ultrasound 2.1
Seoul P4 green
5mm HO Accent LEDs (RB, B, BG and G in the pommel)
Kill/recharge
7.4V Li-ion Solution
Simple LDM PVC Chassis w/snap-in recharge
Custom Aluminum Optics/heatsink module
The Video:
The Build Pix:
The Battery Pack build:
The Glams:
One to go...
Here is the Final Saber in the V2 Project. It is a weathered MR-based V2. Surprisingly, it has the most solder connections of any of the sabers in this project, but the nice roomy insides of the MR hilt were a welcomed sight, especially after working inside that tube that is the Scratch-built V2. DAMN, this sucker is LOUD too.
Particulars:
MR 616 (Jedi font)
Corbin V2 Driver
3.6V 18650 Li-ion Battery solution
Recessed Recharge/kill (Jay-Gon style)
HO 5mm accent LEDs (White in the box, green in the pommel)
HO (and huge) speaker
Cree XR-e Green LED
TCSS BH
The Video:
The Build Pix:
The Glams:
Fin.
Bookmarks