Originally Posted by Skottsaber
Actually, the board is not the same. I haven't heard it, so I will assume it is still sith FX, but the actual board looks like this:
(Image courtesy of Jedi-Supply on "That auction site")
Hello,
Does anyone have a wiring diagram for the above board?
Wire the top wires just like any other newer conversion. Blue+Purple to the positive, all others are negative. The three wires on the bottom are wired like this:
Aluke123 on every other forum
Thread Index, The Saber Building Dictionary, and The Basic Saber-Build Tutorial - Read Them!
And obviously, where the switch is, you would desolder it and run switch wires from the pads.
Click here to learn all about me!
The Shoutbox: The only place you can double post!
Anybody who spells it Lightsabre is dyslexic
"Yeah, if I had Skotts face I'd hit it too" ~ Fenderbender
"You didn't buy a toy saber just to break it. You bought an economy sound card with a really complicated wrapping scheme." ~ Silver Serpent
Just to add a little data here: The SFX coming from this board are a little peculiar. It has the standard blade ignition sound but uses the sith ignition hiss as the impact sound. The idle hum and swing hums are both lower-pitched than normal.
What is life but the passage to death?
Where are the transistors on this?
I'd guess they are surface mount transistors on the other side of the board that the pic doesn't show.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
Posting Permissions
Reply With Quote
Bookmarks