-
Jedi Master
Crystal Focus 3.x problem
I've never had any trouble with the Crystal Focus 3.x in my Qui Gon saber, until today. After recharging it (for the first time in quite a while), a strange thing happened. When I pull the kill-key, the saber makes its standard start-up sound. And when I push the switch, the saber fires up. And immediately fires down. Then immediately fires up again, and fires down again...endlessly.
I tried to reset the board by replacing the kill-key, then holding down the auxiliary button as I pulled the kill-key out again. (That is how to reset the board, isn't it?) Same problem.
Has anyone ever had anything like this happen? Does anyone know how to fix it?
Thanks in advance for any help.
Last edited by Lord Maul; 09-01-2009 at 08:36 AM.
There's always a bigger fish.
-
Council Member
Jedi Master
Just a shot in the dark here, but sometimes my 4.0 acts funny if the SD card isn't sitting right. Try taking it out and putting it back in. Try it a few times to make sure the pads are making good contact.
-
-
-
-
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks