blade question

**Darth Vane** · 08-20-2009, 05:23 PM

Ok i have been searching and reading for about an hour or two. would this help light the tip of the blade?

http://www.thecustomsabershop.com/34...isc--P115.aspx

I cat remember if his will do it or not.

**Sairon** · 08-20-2009, 05:27 PM

If you order the tip with the reflector already on no need for that. It will help bounce the light back down, making the blade look more even.

**Darth Vane** · 08-20-2009, 05:32 PM

I dont think the Bullet tips come with them.

Plus i want the light to Pass through the Blade tip.

**Sairon** · 08-20-2009, 05:34 PM

Bullet tips don't correct, you didn't say that. The only way to alow a little more light in is drill a small through the reflector and into the tip.

**Jedi-Loreen** · 08-20-2009, 06:34 PM

It depends on which 1" blade thickness you're using. That aluminum disk you linked to won't let light through to the thick walled tip, that's the ID of the thick walled blade itself, but it would work for the thin walled 1" blade.

For the thick walled blade, use this one: http://www.thecustomsabershop.com/Mi...Thin-P423.aspx.

You'll probably need to assemble your own blades if you want to do it this way, I'm not sure if you can order it this way by sending special instructions with your order.

The best thing to do is shoot Tim an email and ask.