Grip material for saber.

**$tarkiller** · 08-14-2009, 05:32 PM

alrighty that will do. Thank you!

**Sairon** · 08-15-2009, 08:57 AM

Order a couple lengths of them because sometimes they are not so sticky and come off.

**$tarkiller** · 08-15-2009, 09:16 AM

is there a certain website that would be practical fr ordering those? I googled it, but no luck.

**Eco** · 08-15-2009, 09:32 AM

Good luck, $K.
I know the sites are out there, but I haven't found any heatshrink big enough for even a 1 1/4" sinktube saber.
I'll be watching this thread, too.

**$tarkiller** · 08-15-2009, 10:00 AM

Thanks, Eco. I hope to come up with something good, so I can get look I want.

**Jedi-Loreen** · 08-15-2009, 10:31 AM

You can find large diameter heat shrink here:

http://www.mcmaster.com/#heat-shrink-tubing/=378x1z

**galen marek** · 08-15-2009, 12:27 PM

took a look, couldnt find any self adhesive tubing that will shrink down to the right ID to fit an MHS, the largest shrinks down to 1.2" whereas 1.4" would be more convinient but i reckon that you could get away with it maybe.

**Sairon** · 08-15-2009, 12:34 PM

McmasterCarr has tubing that shrinks down to fit around a choke, just search around.

**Jedi-Loreen** · 08-15-2009, 04:47 PM

Originally Posted by galen marek

took a look, couldnt find any self adhesive tubing that will shrink down to the right ID to fit an MHS, the largest shrinks down to 1.2" whereas 1.4" would be more convinient but i reckon that you could get away with it maybe.

Uh, have you ever used heat shrink tubing? You put it onto the part, then shrink it around that part. You don't shrink it first.

It's not going to shrink any smaller than what you're shrinking it around.