-
Basic Buck Puck Variant LED Wiring with a Latching Illuminated Switch
Okay, here is what I hope is a correct diagram of how to wire up a simple LED saber with a illuminated switch. If it's correct I can make a few more pictures with different options, like a resistor, etc. It should make it so that when you push the button, the saber, and the button light up, and to turn them off you push it again. Am I correct?
-
-
Sith Minion
Id just run the Switch LED straight from the battery pack in parallel with the buckpuck. You wont get much of a result if you did it for the flickering effect. that, and the switch LED would tak part of the current going to the LuxIII making it less bright, which is not so good...
mTm
-
Like this then? I'm not going for a flickering efect or anything, just a simple set up, as I've never done this before.
-
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks