ok so i have spent about two days looking for the answer to this and i personally could not find it.
can i run the LUX III kit from the store with out the resistor? theres going to be no sound and just a stunt saber for now.
ok so i have spent about two days looking for the answer to this and i personally could not find it.
can i run the LUX III kit from the store with out the resistor? theres going to be no sound and just a stunt saber for now.
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
It all depends on the voltage requirements of the LUX III you are using, it can be done.
I'M JUST A SPY(LOL)
i am going to be using the P4 Red.
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
ok , what are the specs for that P4?
Please provide all information.
I'M JUST A SPY(LOL)
ok the minum forward voltage is 2.0.
the typical is 2.3
the Max is 3.0
and i plan on running it with the 4AA setup.
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
4AA= 6 volts....
Unless you want to blow the LED i would recommend getting a resistor.
Got a Question? There's a thread for that...
~Do what you can, with what you have, where you are.~Teddy Roosevelt
SollusVir everywhere else... FXsabers, Youtube, etc...
ok then thanks guys. i cant belive i did not add up the aa's lol
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
Bookmarks