Corbins Board Q

[Hitogiri]

Hi All

When I order a board from Tim it asks if I wanted latching or momentary switch set up. Can someone tell me which is which? What does Tim sell etc.

[xwingband]

It used to be that Corbin only made them in momentary form. This is all because the soundboard. MR's are latching and Hasbros are momentary. Get the one that you are going to be using and/or intend to use, otherwise it shouldn't matter.

<center>Read the FAQ or x-wing won't be happy.
Before posting did you check the Thread Index?.

</center>

[Hitogiri]

Thanks X! Well I wanna use a MR board so I guess I'm going latching!

[Corbin_Das]

Yeah....

What Xwing said......[]

I have the drivers made in either 1 watt (Star O) or 3 watt (Star Hex or K2). The wattage is actually a misnomer, since the drivers don't control wattage, but current. The 3 watter is a 1000mA (1 amp)driver. If you give it about 1 volt more than what the LED calls for, you can run a 3 watt hex, a K2 or even a 5 watt Luxeon. But since most folks don't use 5 watters (I do sometimes), I don't advertise them as "3 or 5 watt drivers" since that would confuse folks.


Corbin