-
vadar conversion Q's
how do i remove the little pin on th epoly carbonate blade?
this one:
-
Owner of the Custom Saber shop
You can pry it out. Or the last one I did I just pushed it in.
Tim
The Custom Saber Shop
-
This is probably a bit of overkill, but I used a small drill and made two holes on either side of the pin. Then, I used some needle nose pliers and it pulled out quite easily.
MythranDir
-
i have a couple question about the vader saber. has anyone ever successfully put one of corbin's drivers into a vader conversion? also, does anyone have a video of a vader saber that has been converted, with or without his driver?
i am a nerd, if you don't like it, i will cut you with my lightsaber
-
Where'd the Vader conversion kit go? I don't see it up on the site anymore, and I just picked up a battered Vader to convert.
-
Owner of the Custom Saber shop
-
Bummer I was going to order a couple of the kits as soon as the store reopened, Oh well I guess I can wait until you make some more.
-
Ok, cool. I was a little worried there you discontinued them. When you get your next shipment in I'll prolly order a few.
-
Just me again. I have my MR Vader totally taken apart. Is there an update on the ETA on the blade holders? I hope I'm not being too pushy. Just excited to do this first project.
-
Owner of the Custom Saber shop
I hope to have them within a few weeks. As soon as I get a better ETA I will let you all know.
Tim
The Custom Saber Shop
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks