Worst mistakes

**Dahi Esmeva** · 06-24-2009, 01:01 PM

lol DJ

**Rhyen Skytracker** · 06-24-2009, 01:50 PM

Originally Posted by DJMoonbass

i rode a stolen shopping cart off of my friends roof into his pool about 3 years ago. i missed the pool. then rolled into it. Worst and funniest mistake in my whole @#$% life.

Did you hit your head DJ? If so, that would explain alot. LOL

**LastODJedi** · 06-24-2009, 02:20 PM

I swapped the diffuser tube from a damaged MR blade to a new poly-c tube. The diffuser had the tip still attached so I left it and slid it into the poly-c tube.

However, I forgot to glue it in.

While messing around with it later I swung it a little too hard and the whole thing shot out like a missile into my Alec Guiness autograph. I only had to get a new frame, luckily Alec wasn't hurt in the melee.

After that, I always make sure my tips are glued in place!

**Barmic Rin** · 06-24-2009, 02:34 PM

We got a video of this shopping cart incident?

Worst saber mistake? Snapped my 03 Luke ROTJ MR saber blade, used industrial strength glue to put back in place, all it did was melt the plastic from around the wires.

They crossed.

They sparked.

The glue caught alight.

I swore & blew it out.

One dead saber & one flat sticking of burnt glue for 2days afterwards...

**Logan Cade** · 06-24-2009, 03:12 PM

Worst saber related mistake?…..Trying my damndest not to scratch a hilt and ending up doing it anyways.
Oh…and sending my US 2.0’s in for the upgrade.

Other then that, it’s been a pleasure.

**jtong77** · 06-24-2009, 03:36 PM

Originally Posted by Logan Cade

Oh…and sending my US 2.0’s in for the upgrade.

Seems like a lot pf ppl has made that same mistake....

**Storm Sunfire** · 06-24-2009, 10:38 PM

Listing that as your worst mistake is wrong. When you are sitting in a shopping cart on a roof looking down at your buddy's pool? That's a whole series of mistakes. Even though I meant lightsaber mistakes, that was pretty damn funny.

**Storm Sunfire** · 06-24-2009, 10:50 PM

Ya know how some MHS parts are narrow inside? When you try to jam a battery pack in there the heatshrink scrapes off the battery right? Well, genius that I am, I decided to save space by putting nekid batteries in the battery holder. Once everything was hooked up the saber was sort of warm then it was HOT. Yow! By the time I had it all pulled apart, the battery holder was a useless pile of slag.

**ARKM** · 06-24-2009, 11:04 PM

Boring a hole through a a piece of solid round aluminum on a lathe and leaving the drill bit inside of it between drilling sessions. Aluminum then cools, contracts and traps the bit. I have ruined at least two emitters and 1 drill bit that way. Never again.