what MHS parts are closest for a KOTOR Darth Nihilus saber? I am doing a DL for a secondary costume for the 501st and this is the one thing I will need the most help with.
what MHS parts are closest for a KOTOR Darth Nihilus saber? I am doing a DL for a secondary costume for the 501st and this is the one thing I will need the most help with.
Last edited by morpheus1977; 06-01-2009 at 10:16 AM.
Could you Post a PIC of the saber you are thinking of!
Got a Question? There's a thread for that...
~Do what you can, with what you have, where you are.~Teddy Roosevelt
SollusVir everywhere else... FXsabers, Youtube, etc...
Hmmmmmmmmmm...
Well I personally would get-
(2) 1.5" Sinktube adapters
(1) 1.5" Sinktube
(1) MPS pommel Style 3 v2
(1) MHS Stlye 1 Choke
and then one or the other
Blade holder stlye 15
Blade holder stlye 5
I think that is the closest you are going to get to replicating that saber without custom work done. Hope that helps some.
Got a Question? There's a thread for that...
~Do what you can, with what you have, where you are.~Teddy Roosevelt
SollusVir everywhere else... FXsabers, Youtube, etc...
blade holder 14 or 18
choke style 1 short
hilt style 1
pommel style 7
Uh, have you tried using the MHS Saber Builder?
Granted, blade holder 18 isn't in there yet, but you can still look at the pics of it in the Store. I think vargose's suggestions are as close as you're going to get with MHS parts. Personally, I think BH 18 is the best choice.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
That looks more like revans saber, Ryhen did a saber like so
I'd use a style 8 blade holder, ten inch section, and some custome sinktube madness.
New to the forum: READ, READ, READ! it's the best way not to get flamed.
Time for a kirby dance <('-'<) (><) <('-')> (>'-')> (>'-'<)<('-'<) (><) <('-')> (>'-')> (>'-'<)
Bookmarks