Ok let the flaming begin....How or should I say which way does the tape go on...sticky side on led board, shiny side on heat sink or just the opposite? Oh yeah this my first build.....FIRE FLAME ON BRING THE HEAT
Ok let the flaming begin....How or should I say which way does the tape go on...sticky side on led board, shiny side on heat sink or just the opposite? Oh yeah this my first build.....FIRE FLAME ON BRING THE HEAT
There are two sticky sides. One side is a little harder to remove the protective tape from.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Ok that did it, thanks.
Bookmarks