I'm stuck. Used the MHS and came up with the attached design. Do I need an adapter if I already have a blade holder for an LED K2 saber? (I removed the adapter for Image #2 but could not upload that image.) I am guessing not. Also, do I need the ring on the pommel to put a D-ring in or can I have holes drilled directly into the pommel? Or would a clip be better to put the saber on a belt and have ready at a moment's notice? I don't really know how that works. Could anyone advise?
How do you attach a C-ring to a pommel insert? I am guessing that I need one with an opening for a recharge port since I am totally new to the field of electronics, sabers, etc. And yes, I did read LDM's tutorial for an MHS LED saber which was very helpful.
I don't even know if this design is viable. Any comments and ideas would be greatly appreciated. Thank you for your time and attention to my questions.
Loremaster
Bookmarks