so Im wiring up a 616 board & a plecter dimmer (not a CF obviously), with a recharge port, 4.8v NiHM battery pack.
and an illuminated DPDT switch..
http://www.rjselectronics.com/PDF/PB613x.pdf
Specs on switch:
VR: DC5V
IF: 20mA
VF Nom: 1.9v
VF Max: 2.4v
My questions are:
1.) do I have the right/correct pinout to the re-charge port? (I believe it is just completing a circuit...(so shouldnt matter..but figured I'd ask)
2.) do I have the switch wired up correctly? using a 120OHM resisitor..
alternately.. I suppose I could run it off the JoeJedi LED leads..but am not 100% about doing that.. just any one?
thanks
Bookmarks