-
Sith Minion
what size set screw to use?
I am making the blade that I bought from Tim a little shorter 40" was a little long. Any way I have to re-drill the whole for the set screw, I looked on the store to see what size set screw he uses so I can pick up the appropriate tap but it does not say. What size tap should I pick up?
-
there is no hole on the blade, the blade will just be a solid tube, you put a set screw or thumb screw in the blade holder.
i am a nerd, if you don't like it, i will cut you with my lightsaber
-
Sith Minion
there is a hole in the blade it goes through the poly carb into the casing of the mono jack to hold the EL wire in base.
-
sorry, sorry, i was think LED blade, not el. you can use any size set screw if you are making the hole yourself. and you don't need a tap for it, you can just drill a hole a bit smaller than the screw and then put the screw into it.
i am a nerd, if you don't like it, i will cut you with my lightsaber
-
Sith Minion
and the threads on it just kind of drill into the plastic it's self?
-
Owner of the Custom Saber shop
The set screw is a 10-32
Tim
The Custom Saber Shop
-
i would go ahead and use the tap to make the threads in the polyc tube. tim gave you the size of the screw, so just get a tap that size, and drill hole a lil bit smaller than tap size and thread the tap in. it will cut the threads in for you.
You dont know the POWER, of the dark side...
-
Sith Minion
-
the tap isn't required though, the screw will cut the threads into the polyC.
i am a nerd, if you don't like it, i will cut you with my lightsaber
-
he can do it either way i suppose, i just threw my opinion out there to consider.
You dont know the POWER, of the dark side...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks