what is a brighter LED a K2 or P4? I am going with a silver LED and i want to have the brightest possible. I am thinking of wiring two 1000 ma buckpucks in a parellel to overdrive it a little for added brightness. Will this work?
what is a brighter LED a K2 or P4? I am going with a silver LED and i want to have the brightest possible. I am thinking of wiring two 1000 ma buckpucks in a parellel to overdrive it a little for added brightness. Will this work?
okay i just found out from master JAY GON that the P4 is brightest by far. now i just need to figure out where to get one and how to porperly overdrive it and what power source to use
P4 stats, 240 lumens at 1000 mah
K2 stats 140 lumens at 1500 mah
So the P4 pwns the K2 and it runs on less mah.
And you will only need one 1000 mah buckpuck if you did two the led would explode, you don't want to overdriver the P4 very much
All you need is a 4 aa battery pack to run your Led or in other words six volts.
Last edited by Sairon; 02-26-2009 at 04:27 PM.
New to the forum: READ, READ, READ! it's the best way not to get flamed.
Time for a kirby dance <('-'<) (><) <('-')> (>'-')> (>'-'<)<('-'<) (><) <('-')> (>'-')> (>'-'<)
thank you very much for the info. thats very helpfull. and sorry for posting the same thing basically a few times. also why am i board lurker? lol
Lol it's okay, to not be a board lurker you have to have a certain amount of posts.
New to the forum: READ, READ, READ! it's the best way not to get flamed.
Time for a kirby dance <('-'<) (><) <('-')> (>'-')> (>'-'<)<('-'<) (><) <('-')> (>'-')> (>'-'<)
Thats what i figured. So basicall her is what i have planes to mount my LED. Take a copper LED heat sink and rest in on a lip on the inside of my hilt and secure it with a few screws between the grooves and then use the nylon screws on the LED it self. But should i just use super glue on the lens and lens holderor what? thats what im kinda confused about....
I have a few posts, and mine dosent say anything, lol...
Winning the fight isn't everything. It's the only thing, and you have two options- TapouT or PassouT.
Official Saber Concepts Saber Designer
It would be fine to glue the lens to the led, but you will never get it off.
New to the forum: READ, READ, READ! it's the best way not to get flamed.
Time for a kirby dance <('-'<) (><) <('-')> (>'-')> (>'-'<)<('-'<) (><) <('-')> (>'-')> (>'-'<)
is that the best way to do it? I would prefer to be able to remove the lens and holder if i ever wanted to exchange electronics....
YEEESSS YESSS YESSS!!!! I AM FORCE AWARE!!!! NO LONGER A BOARD LURKER!!!! thank the yuuzhan vong god Yum Yamka!!!!!
Bookmarks