Ok... I know I can be a bit thick at times, but what am I doing wrong?
Tim was nice enough to make a few ROTJ kits just before Xmas and I picked one up. (Thanks for that BTW Tim!) But now that I'm sitting down to install it I've got a problem.... It doesn't fit?!?
I've stripped/gutted the MR saber as per all the instructions listed both here and on one of my old UltraSaber disks. Everything looks to have went smothly. But when I decided to do a dry fitting before putting it all together... I noticed that the Blade Holder kit doesn't want to come thru the saber body. It appears to stop short by about an inch.
The top of the bladeholder is small enough for the final opening since I can test that from the other direction... but for some reason the main body of the bladeholder is stopping it before it reaches the end anyhow. I don't need to remove the "upper black plastic" from the inside of the saber do I?
I'm confused...
Any Ideas?
-Blair
Bookmarks