mhs parts, o rings, sink tube, handlebar grip, and guts from a MR Vader
mhs parts, o rings, sink tube, handlebar grip, and guts from a MR Vader
changes to mine this week. thanks to jonitus for the inspiration:
My three, Red & Blue are due to be sand blasted & red is getting claw mount & red o-ring grips.
Will snap afew more pics of my Imp Knight for (I believe) Ti-Ell.
XBOX 360 Gamertag AdeganBlue
Being so great, the owner of these wonderful forums and attached shop has filmed how to build an MHS hilt, here's the link:
http://www.youtube.com/watch?v=sm_-BQb_-eY
Is he just great to you all?
My first MHS saber. It has a blade holder #8, ribbed section, double female w/ milled slots, and grip dividers. A 34" blade, 10 degree optics, 3 watt Royal Blue, and a 4aaa battery holder. One of my MR Obi Wan's sacrificed it's, control box pommel, and sound card.
Nice saber Er Dan Gill.
I built up one similar, though without the box, T-grips or brass sections. It's a #8 emitter, ribbed section,
dual female slotted section and the new MPS pommel. I added carbon fiber details between the dividers
and around the neck. There's also O rings on the ribbed section, a covertech knob and a short piece of
T-grip behind a slide switch.
This particular one is using a 5 watt cyan. At C4, this one had an Anakin FX board driving a white K2.
I wouldn't mind eventually having an Ultra board in this.
I had another MHS saber at C4. It was a red/orange saber staff. I just had Ace do some custom machining
on the center section. He added recharge ports, some extra grooves and 3 slots for either sound or a lit
crystal. Here's what it looked like before. I've since blown out the LEDs screwing around with battery pack
configurations/voltages:
I don't have the center section yet, but here's a shot of it Ace sent me. I'm going to put black paint in the grooves I think:
The staff runs on two separate battery packs (each a 3300mAh Li-Ion setup). I enclosed the C cell sized Li-Ion inside a vented
copper sleeve and hooked everything up to that. It's a nice modular setup:
Note, there's a 10,000 mcd 5 mm LED hooked up to light up a central crystal chamber that you'll see through the center slots.
Here's the crystal chamber:
And finally, here's the finished saber:
Corbin
Got my one back from the powder coaters today:
Orange isn't finished yet.
Blue with Extension is mine.
Red is for my bro.
Shorter blue is for a friend.
And with open curtains:
Closer shot of the hilts:
XBOX 360 Gamertag AdeganBlue
Being so great, the owner of these wonderful forums and attached shop has filmed how to build an MHS hilt, here's the link:
http://www.youtube.com/watch?v=sm_-BQb_-eY
Is he just great to you all?
Well, I've finally reached the final stages of the cosmetics for this saber. It's currently got a green K2 straight of 4 AAA's.
My Hilt uses an LED blade holder style 4, MHS ribbed extension v-grooved,
Double threaded hilt style 4, Double ended male threaded connector, MR Luke pommel, 1-3/16" ID O-ring's, Luxeon V Star - Royal Blue, UltraSound, Premium Speaker, 6AA Battery Holder, and craft foam for grips.
Bookmarks