Hi all, I have a few quick questions regarding a saber I recently purchased. The saber functions on a slide switch, and I recently pre-ordered an ultra 2.0 board. So my dilemma is that the 2.0 supports momentary switches and based on the saber design, I don’t know if it would be feasible to install a momentary switch on the saber. I am commissioning the work, but I don’t want to waste my time if it might not be something that works both mechanically and ascetically. With this said I’m looking for a little expert advice. Below is a link to the auction from which I made my purchase to give you an idea of what I will be working with.
On a side note I noticed the LED holder is a little lose, is this something I can secure and how would you suggest I do so (Hot glue?)
http://cgi.ebay.com/ws/eBayISAPI.dll...m=200270807691
Thanks in advance!
Bookmarks