I wasn't able to have Tim do my switch holes so I'm stuck doing them myself. I was going to use a standard TCSS switch (not guarded) with a bezel nut and I know from searching the boards that I'll need a 3/4in switch hole. What I don't know how to do is to recess the switch hole so that the bezel nut will fit flush with the mhs center section. I was thinking of trying to use my dremmel and grind out a recess slightly larger than the bevel, but wanted to consult the masters before possibly ruining my pieces. What can I do? Sending to Tim is not really an option, but I think there's a Machine Shop a few towns over, but don't know if they'll even bother with a job so small as this and drill/tapping a blade holder screw so that's why I may end up doing it myself. What should I do? Before flaming me if this has been asked before - I really did look for an answer, but was unable to find a satisfactory one, so if it's already out there, point me in the right direction.
Sorry to be a pain and thanks in advance!
Bookmarks