-
Using a MR FX tube in a MHS hilt?
I am wondering if it would be feasible to take the innards of a (in this case Yoda) MR FX lightsaber, tube and all and insert it into a MHS hilt.
Then just adding a new switch and wiring the Lux III directly to the board.
Is this possible?
Or would I need a sink tube?
Will the board properly run the Lux III without a buckpuck?
-
-
I have read
I have read and searched on this forum, there just isn't much concerning the Yoda FX.
Now, what I am planning does involve taking the black casing inside the Yoda's hilt and sliding it into my MHS hilt.
This does include using the FX battery/speaker pack as well...
Just so we're clear, this will fit, right?
Also, will the 3 AAA's that go in the Yoda's battery/speaker pack effectively run the Lux III?
Last edited by Boomsticksweets; 10-04-2008 at 06:49 PM.
-
Sith Minion
As stated previously, yes, the innerts of the Yoda should fit. Now depending on the LUX III that you will use it sould also run that as well..the three batteries. Remember these are 3 AAA batteries so your runtime may degrade quickly. You can always make a battery pack up to 6 volts..anything more than 6 volts will fry your Yoda board.
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks