-
Force Aware
Is this correct?
I need someone to look at my terrible MS Paint attempt at a Hasbro wiring schematic and tell me if it's correct, if not, what could I do to simplify it.
Sorry about the disorganized look btw, I threw things in as I thought of them.
Hasbro wiring advanced.jpg
"The crystal is the heart of the blade. The heart is the crystal of the Jedi. The Jedi is the crystal of the Force. The Force is the blade of the heart. All are intertwined: the crystal, the blade, the Jedi. You are one."-Luminara Unduli.
"Scientia postestas est". Knowledge is power.
Proto1b: Dark Gold
-
Force Aware
It looks like the extra power source is going to take up a ton of room, but I don't know how many mA the sound board needs, and driving both LEDs at 3v would be severly underdriving the main LED and overdriving the accent LED.
"The crystal is the heart of the blade. The heart is the crystal of the Jedi. The Jedi is the crystal of the Force. The Force is the blade of the heart. All are intertwined: the crystal, the blade, the Jedi. You are one."-Luminara Unduli.
"Scientia postestas est". Knowledge is power.
Proto1b: Dark Gold
-
Force Aware
If anyone could tell me the required mA for a Hasbro board, then I could wire it directly to the main power source and save a little more hassle.
Oh yeah, I just realised, in my diagram, wouldn't the resistor for my main LED limit the voltage of the sound board?
"The crystal is the heart of the blade. The heart is the crystal of the Jedi. The Jedi is the crystal of the Force. The Force is the blade of the heart. All are intertwined: the crystal, the blade, the Jedi. You are one."-Luminara Unduli.
"Scientia postestas est". Knowledge is power.
Proto1b: Dark Gold
-
Force Aware
Ok, final question. If my setup is entirely wrong (which I suspect it is), could someone please kindly post a schematic for the correct wiring of what I'm trying to achieve, which is a recharge port, a rechargeable battery pack, latching switch for main LED, momentary switch for accent LED, and, if possible, Hasbro wired so that it is turned on when the main LED turns on (if not, its own latching switch will be fine), and wired to the main power source. Resistor values would also be appreciated, and wires colour-coded.
Thank you.
"The crystal is the heart of the blade. The heart is the crystal of the Jedi. The Jedi is the crystal of the Force. The Force is the blade of the heart. All are intertwined: the crystal, the blade, the Jedi. You are one."-Luminara Unduli.
"Scientia postestas est". Knowledge is power.
Proto1b: Dark Gold
-
-
Council Member
Jedi Council Member
A Hasbro board will run a K2 just fine, even though it will be under powered, if you feed it 4.5v.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks