-
Wiring an accent LED
OK, I think I have my first saber almost fully figured out.
Where do I wire the LED? After the switch but before the buckpuck???
Or would i just splice the positive lead on one part of the LED and run a connection to the negative lead of the battery pack?
And if that is the case, would it be before the buckpuck?
Basically would it look like the picture below?
-
-
Wiring?
Ok, I think I got it.
Basically the diagram, but it is hard to see on it. I positive lead from the switch would have two wires coming out of it. One to the positive battery (#1) and one to the LED (through a resistor). Then a wire from the LED to the negative battery post.
Then a wire from the negative post of the buckpuck (#2) to the battery.
Then a wire from the positive LED post of the buckpuck (#3) to the positive post of the LUX III.
Then a wire for the negative LED post of the buckpuck (#4) to the negative post of the LUX III.
Is that right?
And if I understand correctly, one the LUX III, I only need to wire to one positive and one negative post of the star shape LUX III thingy.
Right?
-
-
OK
Yeah I forgot to mention the LED negative to the battery negative.
I will be using this switch:
http://www.thecustomsabershop.com/SP...utton-P44.aspx
And it doesn't look like it has an extra out.....
-
-
So
Basically twist two wires together and solder them on to the switch. One wire to the buckpuck, one wire to the accent LED.
Thanks! Can't wait 'til it gets here! WOOOT!!!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks