-
Cut threading
I want to make a screw together hilt - it's been mentioned a bit in the store wish list and ovbiously the modular hilt system uses this -and was wondering how one would go about cutting threads in 2 pieces of steel pipe to make them screw together. I would go modular but I prefer stainless steel and to have control over length parts and such.
I'm going to contact my black smith but I was wondering if there were any requirements as far as tube thickness and such and if it is an expensive process.
Less talk, more action........
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks