what do you guys use to hone or bore out the inners of your sink tubes..etc..etc


not that I want to take much out..just a nice sanding.. open it up a SMIDGE so some parts slide through a little better..

I looked for a sanding drum but I 1.5 wont fit obviously as the WHOLE tub is 1.5 and 1.25 is too small..

so do I just take a 1.25 sanding drum and try it?..or do I try to craft my own some how? using padding, tape and sand paper on outside??


also,, what do you guys use to sand the inside of the blades?
also what do you use for LONG shanks to make it all the way up and down the tube?

thanks