-
-
Jedi Council Member
wrong..
the blade holder parts have a 1 in hole so the polyC tube (blade) fits in there nice...
you then drill & tap a hole in the side of the blade holder.. NOT THE POLYC TUBE (blade)..
the thumbscrew screws into the bladeholder, tightening the polyC tube to the other side of the bladeholder, essentially pinching it together...make a tight hold.
does that make more sense?
-
Ok...i just got the beginning
So i dont make holes in the tube...only in the hilt?
And the tube fits in the blade holder perfectly is that right?
And after i use screws to make it holder tighter?
ahh..do i have to make holes in the blade holder? wasnt it supposed to come from shop with the holes?
And ok...the blade holder REALLY holds the blade in place yeah?
-
No, you don't make holes in the blade itself.
The blade holder does not come with a thumbscrew, or a hole for it. You have to buy a thumbscrew and drill and tap the hole for it in the blade holder yourself. After you drill and tap the hole, the thumbscrew pushes the blade against the holder and keeps it in place by pressure alone.
-
Jedi Council Member
you can get a blade retnention screw hole made form the shop..but tis a little extra.. since he doesnt knwo where you might want it.. you have to specially request it.
-
Ahhh...now i understood
Well, thank u guys =)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks