My FINAL MHS Design

[Atomic]

I really like the look of that Malaki. I can't wait to see it built.

[Malaki Skywalker]

I really like the look of that Malaki. I can't wait to see it built.

Thanks! I hope to have this at the end of April

[Er Dan Gill]

I agree with everyone else, thats a nice design Malaki.

[Malaki Skywalker]

Will the 4AAA pack give the driver enough juice to power the K2?

Thanks for the comments guys

[Hasid Lafre]

yes, the rest of this post is cause you have to have so many letters inorder for it to post.

[Malaki Skywalker]

I'm using 1.25" PVC Pipe to hold the guts in, will this fit in the ribbed section?

[Hasid Lafre]

No, the normal mhs id is 1.25" so sanding the pipe down will be needed a little bit.

[Malaki Skywalker]

No, the normal mhs id is 1.25" so sanding the pipe down will be needed a little bit.

Ah i see, cheers Hasid

[xwingband]

I'm using 1.25" PVC Pipe to hold the guts in, will this fit in the ribbed section?

If it's the thin stuff the sanding will do no good... you'll sand it out of existance before it fits in the ribs.

[Malaki Skywalker]

If it's the thin stuff the sanding will do no good... you'll sand it out of existance before it fits in the ribs.

Its pretty thick stuff, not to thick though, oh and I'm using a MHS Speaker mount on to hold it in place