View Poll Results: This troubleshooting FAQ/Guide helped solve my CF issue...

Voters
14. You may not vote on this poll
  • Yes! Thanks Erv, thanks Novastar!

    10 71.43%
  • No. Dude... you just bring on the *suck*, N-Star...

    4 28.57%
Page 11 of 11 FirstFirst ... 9 10 11
Results 101 to 104 of 104

Thread: Crystal Focus TROUBLESHOOTING thread...

  1. #101

    Default

    I helped my son install a cfx and everything works but we are getting an overheating warning while everything is in the hilt. Any suggestions on what I can do to, thanks for any help. He has a tri-cree LED and I believe that the resistor is the issue for the red LED but I don't know.
    Last edited by gggLITCH; 05-27-2020 at 02:54 PM.

  2. #102

    Default

    Quote Originally Posted by gggLITCH View Post
    I helped my son install a cfx and everything works but we are getting an overheating warning while everything is in the hilt. Any suggestions on what I can do to, thanks for any help. He has a tri-cree LED and I believe that the resistor is the issue for the red LED but I don't know.
    adjust your htemp settings to a higher temperature
    Props Electronics
    http://www.plecterlabs.com

  3. #103

    Default

    I'm looking to make LED pucks to wire to a PCB neopixel disk for CFX to adapt a neopixel saber into a more combat capable saber for sparring purposes. What kind of power output do I have to accommodate for when choosing my resistor?

  4. #104

    Default

    I can't find out how to change fonts in single switch mode on the CFX.

    I must be missing something glaringly obvious, but I can't seem to find anything about it in the Crystal Focus 10 manual!

    EDIT: After hours of troubleshooting, I finally discovered the secret.

    If anyone else has the same question and comes across my post, hopefully this can help. In order to enter the soundbank selection and change fonts without an auxiliary switch, you must be holding down the activation switch while the saber is booting.

    The easiest way to do this is by holding the activation switch while removing the kill key; however, you can also restart the saber by holding down the activation switch for about 10 seconds (while the saber is already deactivated). Basically, just hold down the button until you hear the words: "soundbank selection". From there, a tap on the button will cycle the fonts forward, while holding the activation switch will select that font.
    Last edited by SonOfRevvan; 06-10-2020 at 02:05 PM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •