TCSS Custom Work

[Strydur]

Had custom work done by us? Post pics here to give others ideas of what we can do.

[Lord Maul]

What was done:

1) Emitter style 2 had three slots cut in it, similar to the ones on emitter style 4.
2) Three style 1 claws were modified to fit directly onto the emitter, no claw mount needed.
3) Double threaded hilt style 2 had three windows cut into it.

[eastern57]

Third (and hopefully final) version of my MHS. Plecterlabs CF v2.63, Lux3 R/O, two long-shaft tactile push-buttons (brown-activation, black-aux)

Custom blade holder style #8. BTW, thanks, Tim, it worked out great!!

go here for full album
http://s306.photobucket.com/albums/n...57/MHS%20Hilt/

[Dark Helmet]

blade holder 7 cut into a crown emitter

[Tomoyo]

Had a custom blade holder made. Combined Blade Holder 6 and the first MHS thin neck together.

[grayven]

Mara Jade Blade holder and 7" Hilt.

[eastern57]

Modified BH #5:

[Jedibum]

Tim did 2 custom emitters for me.


Here's the first one:


Here's some pics comparing it to stock Blade Holder 8






Here are some pics of it on a complete MHS saber





Here's the second custom emitter ... this one is short so it can be combined with Choke Style 2 and keep the length the same as the Kenobi ANH saber.


It's like Blade Holder 8 only shorter ... here's a pic next to the stock Blade Holder 8


Here's a pic showing the length difference with Choke Style 2


Here are some pics showing it next to an Master Replicas LE Kenobi ANH Saber
I wanted to match the Kenobi saber on length from the choke point to the top

[BlackDOG]

Custome machined bladeholder with powder coat.

SWEET!

[Koda Vonnor]

Blade holder and ribbed section turned down (shaved to a bit smaller diameter) to accomodate pre-existing cowls.

Blade holder reshaped slightly for visual effect inside emmiter-shroud.

NOTE: If turning down a diameter on a part that is to be powdercoated, be sure to allow 6-7 thousandths of an inch for the coating. I made that mistake and ended up with a lot more work.