As I build my first MHS, I figured it might be good if I followed a standard for the quick disconnects (QD), so that if I buy other parts, or trade or anything. it's ready to go.

Looking at the tutorial, I did it a little differently, tho if everyone else is doing it the same, I will revert it.

I attached the female of the QD to the LED (same)
I used the black wire as black and the grey stripe as red (different)
I soldered my resistor inline with the QD so it stays with the specific LED (different)

So does anyone have any opinions on this? Is there a lean towards a standard, or does everyone pretty much do what works for them?

Thanks all!