Okay, I've modified the picture from Erv's website and want to know if this will work.
I added the switch on the upperleft for configuring without having to remove the board from the hilt, and the LED along with a quick connector near the battery pack. I'm not totally confident I understand the recharge port, so that might not be included in this saber, but I just want to know if this will work. Also, would there be a way to wire the small LED to the MR switch so that it turns on with everything else instead of always being on when the battery pack is connected, and is the switch I added the correct type for the config?
Thanks for the help and all the great info on this site.
EDIT: okay, I just found Nova's CF wiring guide on youtube and watched part 2.
http://www.youtube.com/watch?v=6uRWr...d=event_802548
At the beginning, he shows the quick connector going to the Lux, but at about the middle of the wire, he splits it off to power a motor. Could I do this for the little accent LED to have it flicker just like the Lux? He says to put on a resistor and with my level of understanding, that would prevent it from flickering. Am I right or wrong.
Bookmarks