If memory serves, the shroud was cut at 30 degrees.
If memory serves, the shroud was cut at 30 degrees.
Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.
Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.
hi..
I jut wanted to clarify here..
for the shroud. did you jus use soe extra 1.5 sink tube that you cut on an angle?
and if fits over the #1 LED emitter/blade holder??
Thanks
Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.
Bookmarks