-
-
-
Corbin's driver
Hi Strydur.
I know this is probably an old thread, but I just thought I'd chime in and mention that the second schematic you have won't work anymore. The drivers now either come in a latching or a momentary On/Off setup and the "default power setting" is set to off.
That means that when you first give power to the driver, it doesn't automatically come on. You'd still have to activate the on/off switch. Before, when the power setting was set to on, when the batteries got low, the saber would flash on and off and you couldn't shut it off without removing the batteries. With it set to off, now you can have an "arming" switch that would be where you show the switch on the second schematic. You'd still have to turn the saber on, but the switch could act as a "safety"
Corbin
EDIT: I'm keeping this post up since it pertains to the diagram but the rest of the discussion should go into another topic. Thanks, xwing.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks