Since I am still a bit lost on how exactly to do this, and I don't want to fry the K2 green I just ordered, I will humbly ask here.
The pre-LED era (1995) Hasbro sound board has an integrated switch pad that I don't think I'll be able to circumvent, but the biggest issue is getting the correct number of volts/amps from the battery to the LED through this board (and speaker and old fashioned spring clash sensor), which was not built with LEDs in mind.
A diagram would be welcome. I've looked at the other Hasbro board thread, but the lack of a motion sensor and the integrated switch pad in this model complicates things for my relatively uneducated-in-electronics mind.
Thank you in advance,
Zero.
Bookmarks