If I read my notes & the TCSS forum sink pipe tutorial by Darthdan, then i should be good to go. Just need the 1.25" sink tube blade holder (black part on this pic) and the assorted electronics & led. I'm probably going to get a 1" - 3/4" reducer too so that when I do fanfilm, i can use the 3/4" dowel/carbon fiber solution instead of the polycarbonate blade (when i get to that point...baby steps ). I do not want the blade holder flush with the custom shroud, but i moved it back what looked like 3/4" to me.
So...if i'm correct...what i'll need is (from TCSS):
1.25" blade holder
Hilt Electronics (kit or otherwise)
LED kit
blade + shouldered tip
Anything else you guys can think of?
Bookmarks