So the other day I was working on my EL saber, the "Agony" from RandomSabers, and was replacing the EL inverter with the one I took out of my blue EL saber that I'm converting to LED, when the wires (the red ones seen in the following pic) that attached to the eL wire in the blade broke off the inside of the hilt:


I took the wires out and completely cleaned the inside of the forward grip/emiiter piece and this was what I found inside:


A mono-jack plug...now, this saber was supposed to have non-removeable blade, so why is that in there? And how the heck am I going to re-solder the wires??!!! I've sent an email to randomsabers asking about the costruction of this half of the saber

to see if I can take it apart and possibly remove and replace the blade. Any suggestions you guys have would be most welcome, as well.