1.25" sink tube

[h4x0rj3di]

If I wanted to build a saber using the 1.25" sink tube blade holder, which parts would I need? Could someone provide a quick tutorial?

[Lord Maul]

read the thread index and FAQ threads before asking these questions please

[h4x0rj3di]

I've checked every tutorial, read through the faq and index, and searched the site, but I cannot find anything on how to install/use the 1.25" blade holder.

Perhaps I should have been more specific : Is the use/installation of the 1.25" holder any different than using a 1.5" sink tube with MHS adapter?

[Strydur]

Not really. It slides in and is screwed in place. Electronics wise it is the same as all of the other LED setups.

[h4x0rj3di]

Is the entire assembly inside the tube or could it be left partly sticking out. I think it might look cool because of the black color doubling as an emmiter, since you can't use an MHS emmiter on a 1.25". Or can you?

[Strydur]

You can leave it partly out yes.

[Novastar]

h4xyorj... you can see how one was mounted to a sink tube here:

http://thecustomsabershop.com/forum/...t=703&start=90

It's as simple as it can get.

THANKS TIM, GREAT part! In my eyes, your best one yet!