-
SD Card read Error after getting back to the build!
Hello,
I was building my second sabre using the CFX chip. There were no issues. I had it on a test bench, wired up and everything worked fine. This was last year and I got busy with other projects so I put it aside. Last week went back to the build and when I try to connect the chip to the software it gives me a SD Card can't be read error! Checked the SD files, they all seem there and look fine. I copied them over to a second MicroSD and get the same error. The computer connects to the chip (It dings when plugged in) and the LED on the card lights up, but the software won't connect. I've tried a few versions of the software as well. Checked all the wiring, re-soldered all the connections to a basic configurations and nothing... Frustrating because it worked fine when I stopped working on it. Any ideas on what could be going on?
Thanks in advance for any input.
-
interesting, can you see if there are any errors when monitoring via the serial monitor? you can use an arduino monitor for this as well, just plug in the USB, keep the SD slightly out of the slot, apply power, connect the monitor software to the board (you should see something about it trying to initialize the SD card) then insert the SD, see where it fails.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks